CS1 CABLE SUPPORT
Two installation options:

Metal Studs         OR           Wood Studs
CS1 is used in a standard round punched opening 1" K.O. (1-3/8 diameter). First snap the mating washer into the K.O. hole in the metal stud. Place wires between the serrated forks and insert into the mating washer section. The CS1 can also be installed with a sheet metal screw on a wood or metal stud by placing the "U" channel portion in the center of the stud and fastening with a screw. You can also install the "U" channel on a wood stud with an NM staple. Cable or cables can then be placed between serrated forks. Install mating washer over serrated forks to secure cable. If necessary, wires can be removed from the support by simply compressing serrated fingers together and
sliding off the mating washer.
CS1







E161207      LR49636
CATALOG
NUMBER		 UPC/DCI/NAED
MFG #01 8997		 UNIT
PKG		 STD
PKG		 HOLE
SIZE		 DIM
A		 DIM
B
CS1 71000 1" K.O. 500 500 1.500 1.640

Note: For position only. For support clips for AC/MC cable see NM310 on page E-2.

 

.