Installation in an irregular shaped hole:

1. Pass the washer section through the hole in the stud.

2. Snap the bushing section and the washer section together.

3. Place wires between the serrated forks and insert into the bushing section.

4. Installation is complete.

Arlington's CS13 can be installed in a standard round punched 1" K.O. (1-3/8 diameter). First snap the bushing section into the K.O. hole in a metal stud. Place wires between the serrated forks and insert into the bushing section. The washer section can either be left attached or can be discarded.

The CS13 can also be installed with a sheet metal screw on a wood or metal stud by placing the "U" channel portion in the center of the stud and fastening with a screw. You can also install the "U" channel on a wood stud with an NM cable staple. Cable or cables can then be placed between serrated forks. Install mating bushing over serrated forks to secure cable(s). The washer section can either be left attached or discarded. If necessary, wires can be added or removed from the cable support by simply compressing serrated forks together and sliding off the mating washer.