Fan & Fixture
Mounting Boxes

To mount fans and fixtures on cathedral ceilings.

FB450

Features and Benefits

  • Installs quickly and securely

  • Fits any cathedral ceiling angle up to 90°
  • UL listed
  • CSA - Acceptable for Fan Support
  • Paintable, textured finish
  • Fan/fixture installation screws are "parked"... ready for easy fan/fixture bracket installation!
  • Screws can not be lost or misplaced

UL listed for fans up to 70 lbs. and fixtures up to 200 lbs.
Catalog
Number		 UPC/DCI/NAED
MFG #01 8997		 UNIT
PKG		 STD
PKG		 DIM
A		 DIM
B		 DIM
C		 DIM
D
FB450 72173 1 6 7.881 .7.881 9.729 3.875
FB900 72174 1 6 7.881 .7.881 6.364 3.875

PATENTED.


E170558

THE SIMPLE WAY TO A GREAT FINISH! 


FB450
FB900
Each kit includes...
Mounting block with built-in electrical box, (1) NM94 cable connector, (4) parked screws.

Note: Install fan or fixture (not included) in accordance with manufacturer's instructions and all local applicable electrical codes, using the parked screws provided. 

Installation Instructions

FB450

FB900
Trim a 2 x 8, approximately 18" long. Allow the panel to extend 9-11" past the FB450. Cut a 2 x 4 approximately 14" long, to span the pitched rafters.
 
 Install the FB450 on the 2 x 8 using the (2) #8 x 1-1/2" long parked screws provided. Install the FB900 in the center of the cut 2x4 using the (2) #8 x 1-1/2" long parked screws provided.
Score and trim the FB450 as necessary, keeping the bottom of the box level. (Short side needs to touch rafter). Nail or screw assembly to rafter. Position the 2 x 4 with FB900 attached to the angled rafters, keeping the bottom of the box level, and the short sides of the box touching the angled rafters. Nail or screw the assembly, spanning both angled rafters.
Push the cable through the cable connector in the electrical box. Push the cable through the cable connector in the electrical box.