|
UL/CSA Listed Box Extenders
|
|
Extend set back metal or non-metallic boxes up to 1-1/2"
|
|
Fast and easy installation – And the remedy
for set back boxes.
|
|
Our new BE3 and BE4 are the
easiest box extenders to use for three- and
four-gang installations. But, if you’re ever
caught short, the flanges of the single-gang BE1
are trimmable for use in multiple gang boxes.
|
BE1 installation
PROBLEM...
Electrical box is set back from wall surface.
|
BE1R installation
PROBLEM...
Ceiling box is set back from surface.
|
 |
 |
 |
|
DO NOT cut the flanges off the outside (left
and right) box extenders (see below).
|
SOLUTION... |
SOLUTION... |
 |
 |
 |
|
DO cut the flanges off both sides of “inner“
BE1 box extender(s).
|
1 Pull wires through, then press the BE1
firmly into the electrical box. To install
without removing the device wires, tilt the
device through the BE1 at a slight angle,
straighten it and tighten the screws!
|
1 Non-conductive BE1R Box Extender installs
easily and extends box flush with ceiling
surface.
2 Install fixture.
|
| |
 |
|
FIXTURE BAR FIRMLY
SUPPORTED
for EASIER CANOPY INSTALLATION!
|
|
 |
2 Attach wires to receptacle. Then tighten
screws for a level, fully supported, code
compliant installation.
|
3 Completed installation...level and code
compliant!
|
